 |
| Tracking control.. |
 |
| 2"x72" Belt grinder 2hp |
Hello everybody !
Well it certainly has been a busy last few months what with the moving of my shop to a different floor in my building and a great deal of different orders from tool and die making to engraving .But the highlight for me has been the completion of my latest self built tool.
A knife makers belt grinder!
Many knife makers end up building their first grinder , usually as a cash saving measure some just for fun. In my case a bit of both.
Indeed it became apparent from the onset of the project that this task was not an easy one.
 |
| Ready for heat treatment. Note the pile of steel wire from | the turning . |
But after it was all said and done I find it has become the most used tool in the shop !
 |
| Early stages |
 |
| Turning down round barstock for a pulley mandrel. |
|
 |
|
Boring out a bearing seat. |
No comments:
Post a Comment